The BSA A7-A10 Forum

Technical (Descriptive Topic Titles - Stay on Topic) => Frame => Topic started by: ADP91 on 11.11. 2020 04:37

Title: S/A footrest support shafts question
Post by: ADP91 on 11.11. 2020 04:37

Hi all,

I have a question about footrest support shafts. I checked the Draganfly catalogue and to my understanding the right and left shafts are different lengths. Unfortunately Draganfly does not stock the RH (shorter?) one.

My question is, would it work to use a LH support shaft on the RH side of the frame? Can't seem to track a RH side one down anywhere...

Thanks!
A

Title: Re: S/A footrest support shafts question
Post by: RDfella on 11.11. 2020 10:54

Cut and weld was my solution.....

Title: Re: S/A footrest support shafts question
Post by: Topdad on 11.11. 2020 11:10

Been looking for over 5 yrs . As yours worn or do you simply not have one ?   Mine became worn on the splines and slipped  I ended up using a fork bronze bush which fitted the outside of the footrest hanger and used that to bring the splined part forward by a qtr of an inch which allowed a new part of the spline to take the weight and me to tighten the nut really well.
If you haven'y got one and  can get the longer one as RD says cut and weld .
Another thought , bit of a long shot , google "Hawksworth motor cycles Ltd " liverpool L23 , 01519490991 ,the owner is associated with Bridge rd motorcycles  crosby  anyway he imported lots of A10 bits , this owner   is a bit wierd but can at times come up with the goods . Hope that helps

Title: Re: S/A footrest support shafts question
Post by: JulianS on 11.11. 2020 13:32

Klemf's list them;

http://www.klempfsbritishparts.com/HANGER--FREST--SPLINED--RH-0