The BSA A7-A10 Forum

Technical (Descriptive Topic Titles - Stay on Topic) => Frame => Topic started by: Stuie on 22.11. 2020 19:20

Title: A7 Rigid Tool Box
Post by: Stuie on 22.11. 2020 19:20

Hello all

How should the tool box be attached to my 1947 a7 rigid, The parts book shows a single bracket which I think goes onto the pillion foot rest bolt but I'm not sure where else it should attach, looking at the tool box i have it has two wholes which line up with the rear mudguard but that seems a bit of a rough idiot way to attach the front of the box.

Thanks

Title: Re: A7 Rigid Tool Box
Post by: morris on 23.11. 2020 20:42

Not sure if it’s the same on a rigid but on a plunger there’s 2 bolts inside to the right holding the toolbox to the mudguard just as you describe.
On the top left there’s a p-clip holding the box to the frame tube coming down from below the saddle

Title: Re: A7 Rigid Tool Box
Post by: Stuie on 29.11. 2020 10:50

Thanks Morris,

Looks like the mudguard is the right place to bolt it, based on parts listing it looks like mine doesn't have the p clip but does bolt to the mudguard.