The BSA A7-A10 Forum

Technical (Descriptive Topic Titles - Stay on Topic) => Gearbox, Clutch, Primary => Topic started by: mario medeiros on 22.04. 2021 22:04

Title: Help with selector plate position please
Post by: mario medeiros on 22.04. 2021 22:04

Can someone draw a arrow on where the spring loaded plunger sits in the plate when it is in neutral I should have taken a better look before I took it apart thanks

Title: Re: Help with selector plate position please
Post by: berger on 22.04. 2021 22:19

drawing arrows is out of my knowledge range , it is the little v shape bottom left 2nd bit in near the mark /stain on the plate

Title: Re: Help with selector plate position please
Post by: Miker on 23.04. 2021 00:37

I saved this pic from the internet when I did my gearbox.

Title: Re: Help with selector plate position please
Post by: mario medeiros on 23.04. 2021 01:20

Thank you both much appreciated

Title: Re: Help with selector plate position please
Post by: Greybeard on 23.04. 2021 16:42

I could not see previous replies so I did one as well

Title: Re: Help with selector plate position please
Post by: Minto on 24.04. 2021 09:14

Very helpful for me too, now if somebody could take a few hundred more photos and draw arrows on them I'll start on my box.
Thanks
Jase