The BSA A7-A10 Forum

Technical (Descriptive Topic Titles - Stay on Topic) => Lucas, Ignition, Charging, Electrical => Topic started by: thackero on 12.12. 2022 13:07

Title: 1962 BSA A10 Super Rocket - Wiring routing required
Post by: thackero on 12.12. 2022 13:07

I am in the process of sorting out my original wiring loom/harness on my A10. I have everything sorted however I am unsure of where the harness was located/routed . Same goes for the dip/horn /cutout switch which is all in one switch. Can anyone post some pictures of how all the wire harness were routed.
i.e. headlamp harness, switch cable on left of handlebar. Left or right of frame etc. etc. ???
Many Thanks

Title: Re: 1962 BSA A10 Super Rocket - Wiring routing required
Post by: Greybeard on 12.12. 2022 16:15

I bought a ready made loom;  when it was laid on the frame it became obvious how it should run.
I put the dipper switch on the drive side of the bike.

Title: Re: 1962 BSA A10 Super Rocket - Wiring routing required
Post by: thackero on 18.12. 2022 15:07

There is a hole with a gromet on the right side of the steering neck. What goes through that ? Switch wiring or throttle cable ?

Title: Re: 1962 BSA A10 Super Rocket - Wiring routing required
Post by: JulianS on 18.12. 2022 15:56

Wiring.