The BSA A7-A10 Forum

Technical (Descriptive Topic Titles - Stay on Topic) => Lucas, Ignition, Charging, Electrical => Topic started by: RoadRunner on 27.03. 2011 18:09

Title: Dynamo wiring connections?
Post by: RoadRunner on 27.03. 2011 18:09

Hi,
Not really another question but would just like to check something - when wiring up the dynamo, do I:
1) strip the end of the yellow and green wires
2) push these ends through the arched bakerlite(?) retaining plate
3) then push the wires through the split brass bullet-like connector (which seem to be a loose fit?)
4) spread the bare wires back up around bullet-like connector

I gather these connections should not be soldered?

Or have I got completey the wrong end of the stick??

Cheers

RoadRunner

Title: Re: Dynamo wiring connections?
Post by: bsa-bill on 27.03. 2011 18:42

Hope you are right - that's what I do

Title: Re: Dynamo wiring connections?
Post by: RoadRunner on 27.03. 2011 21:54

Cheers Bill - couldn't think of doing it any other way but there again.......!

Oh, and how just do you get them to fit in nice and snug?

RoadRunner

Title: Re: Dynamo wiring connections?
Post by: trevinoz on 27.03. 2011 22:12

If the sleeves are loose in the sockets just slip a blade or such into the split and expand them.
  Trev.