The BSA A7-A10 Forum

Technical (Descriptive Topic Titles - Stay on Topic) => Gearbox, Clutch, Primary => Topic started by: terryk on 30.11. 2015 14:32

Title: BSA gearbox in a lathe
Post by: terryk on 30.11. 2015 14:32

There are so many uses for BSA engines and gearboxes here's a gearbox used in a lathe.

https://www.youtube.com/watch?v=n5YtMRlMzQE

Title: Re: BSA gearbox in a lathe
Post by: coater87 on 03.12. 2015 23:19

Nothing like a 10 inch lathe with a 3 inch Chuck powered by a pre-unit 4 speed.

Title: Re: BSA gearbox in a lathe
Post by: Rocket Racer on 18.12. 2015 03:10

probably the earlier C11  4 speed which has both mounts underneath. Basically the same as the A10 box but apparently closer ratio's and of course a slightly different shell.