The BSA A7-A10 Forum

Technical (Descriptive Topic Titles - Stay on Topic) => Gearbox, Clutch, Primary => Topic started by: Tone on 30.03. 2016 19:11

Title: Plunger A10 clutch
Post by: Tone on 30.03. 2016 19:11

Hi All, Can someone please tell me the best way to measure for the thrust washer behind the clutch basket on my plunger A10. And where can I get one from, I've tried Draganfly and looked online, by the was it still has the 6 Spring clutch, cheers

Title: Re: Plunger A10 clutch
Post by: morris on 30.03. 2016 21:51

Hi Tone,
If yours is missing, I think you'll have to do with what you can find. Plunger clutch parts, bar centre and plates, are hard to find.
If you got one, but find the outer basket to wobbly on it, it's possible to skim the back of the clutch centre where it sits against the thrust washer. That's what I did, and it worked out fine.
You may need to revise the chain alignment though.

Title: Re: Plunger A10 clutch
Post by: edboy on 30.03. 2016 22:50

hi tone, i have a spare spacer but no colletts for it i m afraid. if you send a message i will send you my address tomorrow evening.
i m in west london.