The BSA A7-A10 Forum

Technical => Frame => Topic started by: Russ on 10.08. 2017 10:34

Title: Rear guard
Post by: Russ on 10.08. 2017 10:34
I am test fitting my rear guard to my 51 A10. I have two sets of brackets, however, the original one is slightly bent and I need to establish if the other is a correct fit.
If possible, I need the measurements from the bracket mounting points to the guard. "See picture attached".
Thanks in advance,
Russ
Title: Re: Rear guard
Post by: WozzA on 10.08. 2017 11:46
Centre to centre of the holes..
Blue..... 425 mm
Red.....  360 mm
Green... 380 mm
         
Title: Re: Rear guard
Post by: Greybeard on 10.08. 2017 13:08
I'll go and measure mine in a minute..and the mudguard stays!
Title: Re: Rear guard
Post by: Russ on 10.08. 2017 13:13
I rang WozzA tonight after posting this request and at 8.30pm on an average Melbourne night he ventured out to his shed and took the necessary measurements to reply to my post.
Greatly appreciated, thanks mate.
Russ
Title: Re: Rear guard
Post by: Russ on 10.08. 2017 13:16
I should also thank Brian, the photo I used was pinched from one of his earilier posts.
Title: Re: Rear guard
Post by: Greybeard on 10.08. 2017 18:10
Sorry Russ; I forgot.  *conf*

I get 420, 365 and 375 in the same sequence as Wozza
Title: Re: Rear guard
Post by: morris on 10.08. 2017 19:50
420, 365 and 380 mm
Title: Re: Rear guard
Post by: Russ on 11.08. 2017 13:54
Thanks Greybeard and Morris for your helpful input.
Russ