The BSA A7-A10 Forum
Technical => Clutch, Primary, Gearbox => Topic started by: scotty on 03.09. 2017 22:10
-
Trying to remove 6 spring clutch hub centre.
Threads are stripped on it rendering the factory removal tool useless.
Any hints or tips for removal ?
Thanks
S
-
If it's the type that sits on a taper, the only thing that will work is a big enough bearing puller. You may need to loosen the primary inner case to get enough clearance.
DAMHIK
-
Thanks morris I'll give that some thought.
Haynes manual (FWIW) says in absence of the service tool one can whale on it with a hammer and brass drift to loosen the fit on the taper.
Not really seeing that one *eek*
I'll check out pullers tomorrow
S