The BSA A7-A10 Forum
Technical (Descriptive Topic Titles - Stay on Topic) => Frame => Topic started by: Russ on 06.09. 2017 06:45
-
Parts book shows my 51 A10 plunger has the tool box attached at the top, to the frame, by a "P" clip. Are all frames the same or do some have a bracket fitted to attach the tool box.
I was thinking of welding a bracket to the frame to suit. Has anyone done this? or would I be creating unforseen problems for myself.
Russ
-
G'day Russ.
It would be easy enough to make a P clip out of a bit of strapping or tin plate. 1" wide 18 gauge.
Better than welding to a good frame.
Cheers
-
Easy enough to make up. A vice, a round bar of steel from approximately the frame tube diameter, a strip of steel and a hammer is all you need.
-
Electrical conduit clips might work at least as a prototype ?
-
Thanks for your input guys, a "P" clip it is.