The BSA A7-A10 Forum
Technical (Descriptive Topic Titles - Stay on Topic) => Gearbox, Clutch, Primary => Topic started by: Peter Gee on 29.08. 2019 09:32
-
Hi guys, will probably have to have one of these turned from cast iron.
Can someone please give the dimensions of this bush inc the flanged end so I may instruct the turner? Thanks
-
Pete, it looks like could be a kick start drive-section shaft bush maybe??? ...but maybe you need to be more specific to be sure to be sure to be su*bash*....re ... *conf*
-
Hi PG.
You should give the bloke who's doing the machining both the K/S shaft & housing so he can measure both.
The hole in the housing often gets enlongated & if so will need to be bored round again ( oversize)
The shaft also wears & may need to be replaced.
-
And while you are looking there, check the clutch actuator arm hole.
You might want to get that bushed too.
Lee
-
Thanks Coater, I already did that one having found it oval!