The BSA A7-A10 Forum
Technical (Descriptive Topic Titles - Stay on Topic) => Gearbox, Clutch, Primary => Topic started by: jhg1958 on 13.12. 2019 15:35
-
I need to replace the pinion (speedometer worm drive). It is fastened to the layshaft with a peg. Will this just push out? It looks almost riveted in that would need drilling out. However, if i Drill badly any replacement pin will not stay in.
I have access to a press so at least it will not be a hammer job.
John
-
If my memory serves, the pin is peened over. Need to file it flush then tap it out with a pin punch.