The BSA A7-A10 Forum

Technical (Descriptive Topic Titles - Stay on Topic) => Frame => Topic started by: Stephen Arsenal on 12.11. 2009 16:42

Title: this mudguard bracket is´t correctly connected or ??
Post by: Stephen Arsenal on 12.11. 2009 16:42

does´nt seem right to me ? any give advice,also I have two of these screws(one is for the gearbox top adjuster,the other one wo´nt fit underneath the gearbox,so- what is it for ?? can anyone help thank you)..thanks-steve

Title: Re: this mudguard bracket is´t correctly connected or ??
Post by: bsa-bill on 12.11. 2009 16:57

No looks OK to me, needs to be that way as you will see when you get to fit the rear mudguard.

Think you only should have one bolt like that, for the upper gearbox mount as you say.

Looks good from what we can see

Al the best - Bill

Title: Re: this mudguard bracket is´t correctly connected or ??
Post by: Stephen Arsenal on 12.11. 2009 17:08

Thanks bill for the answer,which bolt then goes into the mudguard,because if the rear arms are screwed in,it looks like the mudguard is way to high ??maybe  have the wrong mudguard ??