The BSA A7-A10 Forum
Technical (Descriptive Topic Titles - Stay on Topic) => Frame => Topic started by: Howard on 06.08. 2011 18:37
-
Hi All, I am renewing the rear wheel bearings on my `51 Plunger, however I did not note which way round the spacer between the bearings goes. It protrudes about 5mm on one end and about 2mm on the other end. Any ideas ??
-
The end that protrudes goes towards the brake drum. You may have noticed that side has a washer behind the bearing and the other side doesnt, the protusion is so the spacer clears the washer.
-
Thanks Brian, Regards Howard