The BSA A7-A10 Forum
Technical (Descriptive Topic Titles - Stay on Topic) => Frame => Topic started by: duTch on 19.10. 2011 13:51
-
Heya Folks,
I may have not done it correctly, but posted a couple of queries about the top front engine mount 'Frame Insert' for a plunger A10. I just bodged up a piece of tube roughly the size and'm happy to fabricate same again, but does anyone mind to measure the width of same between frame lugs,and post it up, I tink da frame's a bit bent and need this to fix it properly??? I started building this tractor late '70s from bits and bodges, had it rego'ed till '84 when all went faecal. Now trying to get it happening again, but not a resto job just something to truck 'round on.'
Ta, from duTch
nb It's currently in (almost)as many bits as I can get it into-the speedo worked last time I rode i,t so best left alone!!!!!