The BSA A7-A10 Forum

Technical (Descriptive Topic Titles - Stay on Topic) => Lucas, Ignition, Charging, Electrical => Topic started by: rockthedog on 29.02. 2012 11:37

Title: DVR2 WIRES
Post by: rockthedog on 29.02. 2012 11:37

hi again, you may think i am thick, but have been through the wires for for dvr2  poss earth and i am left with a brown and white wire coming from ammeter, this is per instruction sheet,   GREEN /FIELD-----YELLOW/ DYNAMO----RED/EARTH TO FRAME-------BROWN TO BATTERY VIA BROWN AMMETER WIRE, that leves me with a brown and white wire from ammeter that went on the old reg box A terminal, DO I JUST TAPE THIS WIRE UPor should it go to dvr2 thank you.mal.

Title: Re: DVR2 WIRES
Post by: BSA_54A10 on 29.02. 2012 11:43

One side of the alternator should be connected to the DVR2 negative.
The other side should be connected to the neg side of the battery.

Title: Re: DVR2 WIRES
Post by: iansoady on 29.02. 2012 11:53

Alternator????

The brown from the DVR2 should go to the brown / white going to the ammeter. This then goes straight to the battery. You could connect it as you have done but then the ammeter won't show any charge......

Title: Re: DVR2 WIRES
Post by: rockthedog on 29.02. 2012 12:07

Quote from: iansoady on 29.02. 2012 11:53

Alternator????

The brown from the DVR2 should go to the brown / white going to the ammeter. This then goes straight to the battery. You could connect it as you have done but then the ammeter won't show any charge......

THANK YOU SO MUCH WILL GO AND SWAP WIRES