Just received a new rocker box oil feed pipe. Went for the first 90 degree bend, heated the pipe just above the tee from the banjos and it was perfect. Then for the second 90 bend to route the pipe along the o/s of top tube. Heated the pipe again just started bending when the pipe snapped in two. I don't posses a small tube bender but have bent small tubes by hand for years with no problem. I don't fancy spending another £20 pounds for it to do the same. I prefer not to name the supplier but it was not from Bikerbsa, so has anyone had any luck with fitting these straight silver coloured replacement tubes.
ELLIS