today I installed the clutch assembly and was relieved to find that having fully tightened and locked the centre nut, the chainwheel ran freely with just a trace of lateral play, so I'm happy with that. Fitted the plates, tightening the four springs as per the manual and found that the clutch activation required much more effort than previously so I backed the spring screws off until it was as light as it was when I got the bike. This setting shows about two coils of the springs, and I found that on starting the bike, selecting first and holding the clutch in, it's dragging. I then counted the turns of each screw until it was released and found that he screws are engaged by only four threads, which seems marginal to me, especially as I need to back them off a bit more. Question, please?: obviously, I'm adjusting the clutch prior to fitting the outer casing so when it's fitted, would the addition of oil eliminate the drag, albeit that it's only there to lube the chain?