Got there Musky and I feel a bit silly. My shocks were at 11 1/2 " on the side stand and 12 1/2" off. The turning comment seemed to be an illusion and is best left. This is the best bit. I jacked the rear loop up and took off a shocker, it was on the lowest setting. I assumed I needed some type of 'C' Spanner to adjust the tension, no chance in my cave. I got two small ball bearings, stuck them in the indentations on the adjustment section with grease and clamped the shocker in the vice by the bearings, I simply spun the shocker round with toggle bar to the highest setting. Job done and not a single mark on my new shockers. Now sits proudly on the side stand. Quite pleased with myself at last.