Guys,
That went pretty well. I had a little trouble removing the old bushing, but the pin popped right out- I just had to find it afterward.
I turned the insert from LB, I made it 1/2 thousandth oversize. I heated the cage, used a little lock tite, and will reuse the pin. Probably over kill, but this is the first time I have done this and want to be sure its OK. I had my reamer resized, it will never ream 1.5 inches again, but it will ream any size T/S bushing comfortably.
I still have to drill for the oil and pin, but I left .040 for reaming later. Its a lot and will take some time, but I have no idea how square the bushing will go back into the case. Now I just have to make a guide for the drive side, and ream till my arm falls off.
Lee