Author Topic: auto advance  (Read 163 times)

Offline tlmark

  • A's Best Friend
  • ***
  • Join Date: Aug 2016
  • Posts: 198
  • Karma: 2
  • Maidstone, Kent
auto advance
« on: 15.07. 2020 10:41 »
just checking my auto advance unit never seems to return to the stop, it kinda sits in the middle?
is this because the springs have lost some tension.
Also is it an issue.

Online JulianS

  • 1962 A10
  • Wise & Enlightened
  • *
  • Join Date: Mar 2017
  • Posts: 1075
  • Karma: 20
Re: auto advance
« Reply #1 on: 15.07. 2020 11:31 »
Off the bike the unit should fully return on the springs.

On the bike a bit different because when stationary the light springs are pulling againts armature weight and friction in bearings brushes etc. Kick bike over and it should fully return.

beezermacc

  • Guest
Re: auto advance
« Reply #2 on: 15.07. 2020 18:23 »
Just copied this off my website. It may help.
A bit of ATD theory!
ATD's can be a bit baffling! Occasionally customers phone me, whilst fitting their magneto, to ask if their ATD is faulty. The conversation goes like this... "I'm fitting the magneto and just about to fit the ATD. When I hold the ATD in my hand it flicks back OK but as soon as I start to tighten it onto the magneto shaft it doesn't seem to flick back properly. I can move it backwards and forwards by hand but it seems to have gone stiff and won't flick back on its own. I've taken it off again but I can't find anything wrong with it. What's going on?!"
Think of the ATD as a component that works in three stages....  1) the fixed gear picks up drive from the engine then.....  2) the drive is passed on to a flexible connection made of springs and bob weights, then... 3) the drive is collected from the flexible mechanism by a nut fixed onto the magneto armature shaft. Remember that the gear is fixed because it is meshed to the camshaft gear, so the springs are trying to pull the magneto armature back to the 'at rest' position whilst one end of each spring is attached to the gear and the other end of each spring is attached to the armature shaft. Now here's the critical bit.... (and the reason why the ATD doesn't flick back when stationary) ... the magneto armature is not free-floating because there is friction and magnetism in the magneto which prevents the armature responding fully to the pull of the springs. The friction/resistance is caused by the pickup brushes, earth brush, heel of the points, drag in the bearings and the attraction of the magnets. As the engine is turned over very slowly the friction is reduced because the parts are moving - sliding over each other, and the springs are able to pull the mechanism to its 'at rest' position. You can test this by turning the bike over slowly on the kick start and watching the ATD return to its fully retarded position - Hey Presto!
ATD units are not very sophisticated but they do need to work properly. The springs should be strong enough to return the unit to 'fully retarded' as the engine comes to rest - this will enable you to start the bike again without getting launched over the handlebars. If the springs are too strong they will prevent the magneto advancing soon enough which may cause overheating and sluggish running. Springs which are too slack will advance the spark too soon causing advancement at kick start speed (kick-back) and spitting in the carb when blipping the throttle.
 

Offline tlmark

  • A's Best Friend
  • ***
  • Join Date: Aug 2016
  • Posts: 198
  • Karma: 2
  • Maidstone, Kent
Re: auto advance
« Reply #3 on: 16.07. 2020 15:57 »
Excellent makes perfect sense now, thanks Beezermacc