BSA A7 Dynamo drive issue

[DaveB500]

Hi all, I have just starting working on a 1960 BSA shooting star.
The bike rides well, and is part restored.
Problem I have is no output from the dynamo.
This is due to the chain and lower drive sproket.
The chain has snapped at some stage, also all the rivets holding the drive sproket to the carrier have sheared.
I have sourced a new chain, but wondered if any of you have re-riveted the sproket and carrier back together.
What rivets did you use, and was it succesfull.

Chears

Dave

[minibsa]

Hi Dave,  It would probably be easier to buy a new sprocket.
Cheers,   Bob.

[a10 gf]

I did it for fun, http://www.a7a10.net/BSA/E3L.htm , but could have used rivets or bought a new one.

[DaveB500]

Thanks guys,
Been hunting for a new one, not found any about even on Flebay.

Will use the screw and nut way. 

[shabashow]

That's why I recently replaced my chain with a belt drive
John

[orabanda]

Dave,
Where do you live?
I've got one you can have, for the cost of postage.
Richard

[A10Boy]

I saw one on ebay just yesterday..

[DaveB500]

Richard I live in Leeds in the UK

[orabanda]

Dave,
I have got over the Ashes, and am prepared to post to Leeds!
Email me your adress.
Regards,
Richard

[DaveB500]

Good job im not a cricket fan...

email me on sales@jr-ink.co.uk

I will reply with my address for you.

Dave