Author Topic: Crankshaft shims a10 preunit  (Read 6069 times)

Offline trevinoz

  • Newcastle, N.S.W. Australia.
  • Wise & Enlightened
  • *
  • Join Date: Jul 2006
  • Posts: 2903
  • Karma: 67
Re: Crankshaft shims a10 preunit
« Reply #30 on: 21.12. 2013 21:57 »
Hi Richard,
                    I agree with Musky re checking the rods for centre. I have never shimmed to that degree, either. Can't remember exactly what I have done but definitely not that much.
If you know a friendly machinist it shouldn't take much effort to make a spacer to fit the shaft but if you do ensure that it is radiused internally  to fit the crank.