The crack in my crankcase (in the worst buy/bike in the world) is getting worse, I have started stripping the engine out, can anyone recommend a good ally welder in mid Wales? Im sure srm would do it, but I dont think I could afford! And wheres the best place to get a plunger gasket set, there seem to be countless versions/types/makers/suppliers. Cheers all. Oh, and theres a thumbnail sized chunk missing from the front skirt of my piston, at the bottom, should I replace it or can I get away with leaving it (I'm horribly skint) Theres no crud in the sump, so I'm guessing the crankcase crack and the chunked piston happened together, a while ago. Please nobody tell me to do the whole engine properly, I figure a shagged out bike on the road is better than a pile of bits awaiting funds in the shed.