Author Topic: a7 pushrods  (Read 396 times)

Offline Hyde61

  • Moving Up
  • **
  • Join Date: Apr 2012
  • Posts: 8
  • Karma: 0
a7 pushrods
« on: 16.05. 2012 13:55 »
HI JUST  PUT MY A7 ENGINE TOGETHER AND HAD A REAL PROBLEM FITTING THE ROCKER BOX IE THE PUSHRODS NIGHT MARE TOOK AGES THEY SEEM TO BE ENGAGE RIGHT ,PUT WHEN YOU KICK THE BIKE OVER SHOULD YOU SEE ALL FOUR MOVE UP AND DOWN .I NOW THIS IS SOUNDS LIKE A DAFT QUESTION PUT IS THERE A WAY THAT YOU CAN TELL THEY ARE SITTING RIGHT.
Good Advice
0
No reactions

Offline Goldy

  • Warwickshire, England
  • Resident Legend
  • *****
  • Join Date: Dec 2008
  • Posts: 619
  • Karma: 9
Re: a7 pushrods
« Reply #1 on: 16.05. 2012 16:12 »
Yes the rocker box can be a bit of a pain. If you get a small torch with a small point beam, you can see the ends of the rockers sitting in the pushrods. The  two exhausts can be seen from the front and the two inlet from the back, it helps if you have a small dentist type mirror that you can get from tool sales, and yes afterwards you will see each rocker move. You will find a few posts on this is you do a search. all the best with it.
Good Advice
0
No reactions
56 A10 Golden Flash - Restore, ride, relive.                                          
56 C12 BSA project ongoing