Info required re '54 / '55 rear hub components

[orabanda]

Hi All,
Can someone please clarify the following:

(a) 65-5883 rear hub ball bearing; what is the code for the bearing please? 2RS (both sides sealed) is preferred.
(b) 67-6032 Rear hub collar; what are the dimensions (I wish to make one)
(c) 67-6028 Axle distance sleeve (RH side); dimensions please
(d) 67-6030 Rear brake drum bearing sleeve (short axle inside brake drum); basic dimensions required. I have one, but am unsure if it is correct for this hub, so need measurements.

Many thanks,
Richard

[tombeau]

Scotty very kindly measured up his components for me when I ran into difficulties.
Dimensions can be found here:

http://www.a7a10.net/forum/index.php/topic,874.msg5712.html#msg5712

Cheers,
Iain

[Brian]

The bearing is a RLS7, 2" OD, 7/8" ID, 9/16" width.

Just for interest here is a pic of my bearing chart, its an original factory chart.

[orabanda]

Tombeau and Brian,
Thanks for the help; what nice folk you are!

Considering making you both honourary West Australians!!!

Regards,
Richard

[trevinoz]

Richard,
                 Ask Brian nicely and he may give you those dimensions.
I measured and sketched them for him when he was building the rigid.
Rigid is the same as '54/'55 swinging arm.
Trev.

[Brian]

I e-mailed them direct to Richard Trev, it took me awhile to find them and I scanned them at a high resolution which made them a bit big to post on the forum.