« previous next »
Pages: [1]   Go Down

Author Topic: Primary cover cork gasket  (Read 1010 times)

Offline Duncan R

  • Valued Contributor
  • ****
  • Join Date: Sep 2008
  • Posts: 291
  • Karma: 3
Primary cover cork gasket
« on: 02.07. 2012 20:39 »
Hi All.

Just about to fit the primary cases and I have some cork gaskets - Do you use any type of sealant with cork?

Many thanks

Duncan
Logged
Anglo - Indian A7SS (Actually is a 650)
Kawasaki ZZR 1100
BMW R80GS
BMW R1100GS

Offline Goldy

  • Warwickshire, England
  • Resident Legend
  • *****
  • Join Date: Dec 2008
  • Posts: 619
  • Karma: 9
Re: Primary cover cork gasket
« Reply #1 on: 02.07. 2012 21:38 »
The cork of course will compress to form the seal, but I usually put a thin layer of grease on each side first.
Logged
56 A10 Golden Flash - Restore, ride, relive.                                          
56 C12 BSA project ongoing

Offline Duncan R

  • Valued Contributor
  • ****
  • Join Date: Sep 2008
  • Posts: 291
  • Karma: 3
Re: Primary cover cork gasket
« Reply #2 on: 03.07. 2012 08:35 »
Thanks Goldy,I will give that a go - was not sure if sealant would spoil the cork

Logged
Anglo - Indian A7SS (Actually is a 650)
Kawasaki ZZR 1100
BMW R80GS
BMW R1100GS

Offline BSA_54A10

  • Wise & Enlightened
  • *
  • Join Date: May 2008
  • Posts: 2544
  • Karma: 37
    • BSA National
Re: Primary cover cork gasket
« Reply #3 on: 03.07. 2012 10:07 »
No it will not hurt the cork.
Generally I use Hylomar on the cover & HT grease on the case.
This allows the gasket to come off cleanly whenever you remove the cover.
Logged
Bike Beesa
Trevor

Offline Duncan R

  • Valued Contributor
  • ****
  • Join Date: Sep 2008
  • Posts: 291
  • Karma: 3
Re: Primary cover cork gasket
« Reply #4 on: 03.07. 2012 17:49 »
Thank you Trevor - I might put some Wellseal on it as it is normally the part that is most prone to leaks

Duncan
Logged
Anglo - Indian A7SS (Actually is a 650)
Kawasaki ZZR 1100
BMW R80GS
BMW R1100GS
Pages: [1]   Go Up
« previous next »