Hi all, My A10 is apart at the moment as I had dropped part of a very thin thrust washer. How did I know, well thats thanks to the SRM sump magnet and the fact that it still wet sumps, so I was draining it as it had been stood a while.
I was being lazy and unknowledgable when I rebuilt it originally in that the scavenge pipe does not fit through the hole in the mesh properly it seems to be off line, so I enlarged the hole!!, defeats the object I suppose. Can the scavenge pipe be removed/replaced or could I try applying heat to the scavenge pipe and bending it to fit?.
Also should the end of the pipe be flush with the mesh or should it stick through it, if so, how far.
Please see my other post about the oil retaining ball. (I think that's why it still wetsumps).
Regards Huddie