Hi Guys,
I bought a new drum / sprocket for my RGS Rep (42 teeth) along with new nuts bolts and the tab washers to fix the driving flange on. I also ordered new bearings. When the hub arrived I noticed that the diameter of the bearing recess was about 50mm whereas the diameter of the original was about 57mm. It was a cheap one supplied by Len Craig of Great Yarmouth ( cost about £60 ) I therefore sent it back for a refund. However I also ordered a new circlip part number 67-6034. I tried to fit it to my existing hub but it is too small It seems that the new drum may have been correct and my old one is not??
I am happy to stick with my existing hub as I was only replacing it for cosmetic reasons. Any ideas?
Also, does anything fit between the Rear Brake Outrigger Strap 67-6046 and the brake cover plate?
Thanks in anticipation
Mark