Rear QD Wheel hub ?

[A10 JWO]

I am taking my wheel apart ready for a rebuild it is a quick release type on an A10. I cannot see how to get the round plate off the non drive side. Has any one got a breakdown of this type of hub please. The plate is some sort of trim that hides the spoke seats in this crinkle hub nearest the spacer.


Thanks Colin

[Rgs-Bill]

Colin, Draganfly has a dis-assembled blow up of the entire rear QD wheel and axle set up, showing everything you need to know.   I am new to "puters" and do not know how to send a link from some where else in the web to you , or I would do that.
                                    RGS-BILL

[morris]

I think this is what Bill means;

http://www.draganfly.co.uk/data/pdf/ListB3.pdf

It 'll take some time to download, but worth keeping somewhere on your pc

[BSA_54A10]

If you are talkmg about the naive plate ( pretty cover plate ) it just "pops off.
The rolled lip is slightly smaller than 90 deg so when it is tapped on with a rubber mallet it stretches over the hub.
If you are not replacing the wheel bearing then tap the edges using a bit of hardwood as a drift.
If you are replacing he wheel berings they drive out with the wheel bearing.