Author Topic: Main Bearings  (Read 735 times)

Offline Russ

  • A's Best Friend
  • ***
  • Join Date: Aug 2009
  • Posts: 208
  • Karma: 1
Main Bearings
« on: 05.09. 2013 03:03 »
I am in the process of finding parts for my future engine rebuild and have queries RE the main bearing / bush.  Firstly, what new / modern bearing do I use to replace the original Drive side bearing?
Secondly, my Timing side Bush is 22 thou undersize.  I see on Ebay that 20 thou undersize is available. This will give me 2 thou play but I am guessing this to be too much. Do I need to get a standard bush and have it machined to suit?  Draganfly refer to this bush as a Bearing. Is this simply a difference in description or is it actually replaced with a new / modern bearing?

Russ
1951 A10 Plunger.
Australia

Online KiwiGF

  • Last had an A10 in 1976, in 2011 it was time for my 2nd one. It was the project from HELL (but I learned a lot....)
  • Wise & Enlightened
  • *
  • Join Date: Feb 2011
  • Posts: 1409
  • Karma: 12
Re: Main Bearings
« Reply #1 on: 05.09. 2013 07:22 »
Re the plain bush, best thing to do is get the minimum ground off the crank to make it round then get a one off bush made to suit the crank, line reamed in situ to final size, preferably. Lots of info on this forum on that job.

You might be able to make the one off bush from a std bush but the chances are the case housing will be oversize, so you need a one off bush for that reason anyway.

Re the roller bearing, the usual suspects supply those eg draganfly I dont think you will find much lower prices buying from bearing suppliers like skf , toyo etc but you never know, its important to get the version of the bearing that allows for the slight shrink caused by pressing the outer into the case referred to as something like "c class fit" or similar, eg you dot want the tightest clearance version of the bearing.
New Zealand

1956 A10 Golden Flash EA7-168x, CA10 913x, left BSA together for Liverpool, 5th Dec 1955.

1949 B31 rigid “400cc hot rod” (favourite bike)

1949 C11 rigid, but why!!! (cos it was cheap)

1937 B21, missing parts so mission impossible?

1952 Armstrong Siddeley Whitley for rainy days (with wife).

GL1800 Goldwing not sure why, maybe cos it always starts

Online orabanda

  • Resident Legend
  • *****
  • Join Date: Nov 2008
  • Posts: 981
  • Karma: 21
Re: Main Bearings
« Reply #2 on: 05.09. 2013 08:58 »
I like the drive side roller bearing to have a plastic retaining cage (for the rollers), rather than a steel cage. I have been able to buy this version from SRM and Lyford Classic Services, but others may be able to supply this type as well.

The reason is that it is easy (straight-forward) to remove the rollers from the cage (they just push out), so that a split puller can be located against the upper lip of the inner race, and the race removed without damage, if the shimming (for crankshaft end float) has to be adjusted.

The bearing is then easily re-assembled (rollers just push back into the retainer).

Richard