New rebuild 1963 A10

[trevinoz]

I wouldn't worry about the carby settings.
Just ride the bike normally without lugging it on hills, revving won't hurt it.
Make sure that the bloke that bores it gives it enough clearance.

[magicflem]

Thanks Trev. The GPM pistons spec is 3 to 3.5thou piston to bore clearance. Is this too little?
Kim

[trevinoz]

Kim,
          I would give it another thou but it is up to you.

Trev.

[morris]

Service sheet 216 says .0011 to .0031

[muskrat]

That would be for split skirt pistons Morris. I agree with Trev, 4 - 4 1/2 thou is good.
Cheers