« previous next »
Pages: [1]   Go Down

Author Topic: A10 speedo gear on lay shaft  (Read 466 times)

Offline jfligg

  • Valued Contributor
  • ****
  • Join Date: Aug 2006
  • Posts: 268
  • Karma: 1
A10 speedo gear on lay shaft
« on: 22.03. 2015 15:30 »
Hi Guys
I am trying to remove the speedo drive from the lay shaft of a A10 gearbox. Anyone ever done this? I drilled out the pin. No dice. I heated the lay shaft. No dice. Any one ever do this successfully. Thanks Jeff
Logged

Offline trevinoz

  • Newcastle, N.S.W. Australia.
  • Wise & Enlightened
  • *
  • Join Date: Jul 2006
  • Posts: 3189
  • Karma: 71
Re: A10 speedo gear on lay shaft
« Reply #1 on: 22.03. 2015 20:44 »
I have done several, Jeff.
I hold the gear between aluminium angles in the vice and work the shaft free.
Logged

Offline duTch

  • Ricketty Rocketty Golden Flashback
  • Wise & Enlightened
  • *
  • Join Date: Oct 2011
  • Posts: 4528
  • Karma: 41
Re: A10 speedo gear on lay shaft
« Reply #2 on: 23.03. 2015 01:36 »

 I was looking at one (two) the other day, and decided that as the shaft is hollow, it could be possible to slide in a length of bar and drift it out? Being careful not to burr the end though
Logged
Started building in about 1977/8 a on average '52 A10 -built from bits 'n pieces never resto intended -maybe 'personalised'
Have a '74 850T Moto Guzzi since '92-best thing I ever bought doesn't need a kickstart 'cos it bump starts sooooooooo(mostly) easy
Australia
Pages: [1]   Go Up
« previous next »