« previous next »
Pages: [1]   Go Down

Author Topic: Gearbox plunger thread  (Read 465 times)

Online a101960

  • Wise & Enlightened
  • *
  • Join Date: Sep 2007
  • Posts: 1072
  • Karma: 12
  • BSA RGS BSA C12
Gearbox plunger thread
« on: 21.08. 2017 16:57 »
Can anyone tell me what the gearbox case plunger thread size is please? I need to buy a tap to give it a clean up. The plunger was quite tight when I unscrewed it and it does not want to screw all the way back in.
John
Logged

Online JulianS

  • 1962 A10
  • Wise & Enlightened
  • *
  • Join Date: Mar 2017
  • Posts: 1395
  • Karma: 29
Re: Gearbox plunger thread
« Reply #1 on: 21.08. 2017 18:39 »
It is 5/8 inch x 20 tpi cycle thread.
Logged

Online a101960

  • Wise & Enlightened
  • *
  • Join Date: Sep 2007
  • Posts: 1072
  • Karma: 12
  • BSA RGS BSA C12
Re: Gearbox plunger thread
« Reply #2 on: 21.08. 2017 19:32 »
Thanks for your help Julian. I must say the taps took a bit of tracking down. The obvious vendor Tracey Tools didn't have any in stock. I managed to order a set from RGD Tools. Once again thanks for your help mate.
John
Logged

Online a101960

  • Wise & Enlightened
  • *
  • Join Date: Sep 2007
  • Posts: 1072
  • Karma: 12
  • BSA RGS BSA C12
Re: Gearbox plunger thread
« Reply #3 on: 23.08. 2017 15:36 »
Julian, the taps arrived in the post this morning. I ran a tap throught the plunger hole and the thread cleaned up nicely, so the plunger is back in the box now. Once again thanks for the heads up on the thread size.
John
Logged
Pages: [1]   Go Up
« previous next »