Author Topic: ATD fibre gear teeth  (Read 494 times)

Online JulianS

  • 1962 A10
  • Resident Legend
  • *****
  • Join Date: Mar 2017
  • Posts: 871
  • Karma: 18
Re: ATD fibre gear teeth
« Reply #15 on: 09.12. 2018 13:10 »
Gear meshing.

This is how it looks on my A10.

Offline Swarfcut

  • Resident Legend
  • *****
  • Join Date: Oct 2018
  • Posts: 597
  • Karma: 8
Re: ATD fibre gear teeth
« Reply #16 on: 09.12. 2018 13:26 »
 G'day... It is a simple case of lulling you into a false sense of security. It knows!!!  No, not really.  This engine in its standard form will still run pretty well despite neglect and mal adjustment. This is why when set up to perfection the performance can be absolutely phenomenal. They really can move in mysterious ways, defying all logic.  Treat it gently as you start to learn its foibles, reckon you have a winner there.

  Just checked the wear pattern on an ATD gear...the mesh pattern is almost to the bottom of the fibre teeth, so either you have a bad or worn gear, or the maggy is fitted a bit too far back. The depth of mesh is acceptable for light local use, but not really reliable enough for highway trips. Try slackening the three retaining nuts and see if you can move the maggy  a bit closer. The fibre gear is replaceable, fiddly to do. You need one with 44 Teeth if you go searching for another ATD.

  Bergs, just heard from the pub...red carpet awaits. I am booking an eye test tomorrow.

 Swarfy.

Offline UncleD

  • Moving Up
  • **
  • Join Date: Jul 2018
  • Posts: 85
  • Karma: 0
  • My giddy aunt!
Re: ATD fibre gear teeth
« Reply #17 on: 11.12. 2018 08:28 »
JulianS...that's how mine look...the black tooth tips are just had to see.  Thanks to all for the attention though.

Northern Territory, Australia

Online Greybeard

  • Jack of all trades; master of none.
  • Wise & Enlightened
  • *
  • Join Date: Feb 2011
  • Posts: 5318
  • Karma: 27
Re: ATD fibre gear teeth
« Reply #18 on: 11.12. 2018 12:23 »
...I replaced the washers...
If you remove the pump; just in case you don't know: The nose of the oil pump needs a fibre washer under the body so that it is at the same level as the main part, that has a gasket under it. If it's not fitted, the pump body will get distorted.

Online metalflake11

  • Resident Legend
  • *****
  • Join Date: Aug 2012
  • Posts: 574
  • Karma: 9
Re: ATD fibre gear teeth
« Reply #19 on: 27.03. 2019 22:03 »
Any recommendations for an auto advance fibre gear somewhere near Manchester anybody?

I'm desperate, and unfortunately Priory Magnetos are shut for holidays. *sad2*

Also, does anybody know the spec/size for the rivets please!

Thanks in advance chaps!
England N.W
1960 A10
England