Author Topic: Magneto issues?  (Read 3757 times)

Offline BSA_54A10

  • Wise & Enlightened
  • *
  • Join Date: May 2008
  • Posts: 2544
  • Karma: 37
    • BSA National
Re: Magneto issues?
« Reply #15 on: 25.03. 2013 12:30 »
I don't actually use mine for tuning unless I am in deep trouble or way out of my depth ( most of the time ).
What I use it mostly for is fault finding.
Really good particularly on late A65's with the carby balance tube.
No need to touch any of the owners "tuning" and I can show them where they went wrong ,
just about every one that has fronted up at my place was running both pots at idle off one carb
Bike Beesa
Trevor

Offline mayes

  • Moving Up
  • **
  • Join Date: Mar 2013
  • Posts: 42
  • Karma: 0
Re: Magneto issues?
« Reply #16 on: 07.04. 2013 15:20 »
Hi Check that you are running on non resistance spark caps also I was caught out with the cut out switch not fully disconnecting witch gave a weaker spark when hot ,hope this helps Jon   
bike running in rider running out
Tri 500 5Ta
B.S.A A10 1955 Under restoration

Offline A10 JWO

  • Resident Legend
  • *****
  • Join Date: Oct 2012
  • Posts: 730
  • Karma: 2
Re: Magneto issues?
« Reply #17 on: 07.04. 2013 16:04 »
Spot on Mayes, A bloke from Hullbridge gave me that good advice as well. Watch those cut off switches on the KF2 Mag'
: )


Offline BSA500

  • Resident Legend
  • *****
  • Join Date: Dec 2007
  • Posts: 911
  • Karma: 4
  • Tonbridge,Kent,UK
Re: Magneto issues?
« Reply #18 on: 07.04. 2013 19:16 »
I have disconnected the wire and will check it out tomorrow on the way to work.Fingers crossed.

1960 A7 (57 motor to SS spec)

Offline BSA500

  • Resident Legend
  • *****
  • Join Date: Dec 2007
  • Posts: 911
  • Karma: 4
  • Tonbridge,Kent,UK
Re: Magneto issues?
« Reply #19 on: 08.04. 2013 09:17 »
No change. Just to recap.... Fresh plugs and leads, no supressed plugs or caps(in fact no caps wired direct to plugs). The stutter is still there regardless of carb fitted. Ticks over and revs a treat just the stuttering when accelerating hard and gets worse the warmer the engine gets. It has a nice long run into work each day 13 miles each way. I would like to see if anything changes as the weather warms up but it seems that's still a way off *sad2*. I still intend to have the 1 inch carb resleeved and new needle jets etc when funds allow just to hopefully rule that out.
Could this be a condenser on its way out,if it is its taking a damm long time to fail. As an aside I had to fit B7ES plugs as the others(B6ES) failed as NGK seem to in under a year. It now pinks which is why I used B6ES.

1960 A7 (57 motor to SS spec)

Online muskrat

  • Global Moderator
  • Wise & Enlightened
  • **
  • Join Date: Jul 2009
  • Posts: 10754
  • Karma: 130
  • Lithgow NSW Oz
    • Shoalhaven Classic Motorcycle Club Inc
Re: Magneto issues?
« Reply #20 on: 08.04. 2013 10:35 »
G'day BSA500. Retard the ignition a tad. A hotter plug won't help pinging, but it will help burn a richer mixture to combat pinging.
Is it a manual or auto advance?
Cheers
'51 A7 plunger, '57 A7SS racer now a A10CR, '78 XT500, '83 CB1100F, 88 HD FXST, 2000 CBR929RR ex Honda Australia Superbike .
Australia
Muskys Plunger A7

Offline BSA500

  • Resident Legend
  • *****
  • Join Date: Dec 2007
  • Posts: 911
  • Karma: 4
  • Tonbridge,Kent,UK
Re: Magneto issues?
« Reply #21 on: 08.04. 2013 12:28 »
Auto. Checked the weight action on the atu and that's fine will have a check on the timing when I have a chance to see if its not slipped or anything

1960 A7 (57 motor to SS spec)

Offline a10 gf

  • Global Moderator
  • Wise & Enlightened
  • **
  • Join Date: Sep 2006
  • Posts: 3180
  • Karma: 57
  • West Coast, Norway & Alpes Maritimes, France
    • A10 GF
Re: Magneto issues?
« Reply #22 on: 08.04. 2013 12:31 »
Maybe worth to try a Brightspark EasyCap, see http://www.a7a10.net/forum/index.php?topic=5359.0


Stand with
A10 GF '53 My A10 website
"Success only gets you a ticket to a much more difficult task"

Offline BSA500

  • Resident Legend
  • *****
  • Join Date: Dec 2007
  • Posts: 911
  • Karma: 4
  • Tonbridge,Kent,UK
Re: Magneto issues?
« Reply #23 on: 08.04. 2013 13:09 »
Don't really want to start cutting the mag about unless I am sure there is a issue

1960 A7 (57 motor to SS spec)

Offline A10Boy

  • Wise & Enlightened
  • *
  • Join Date: Jun 2008
  • Posts: 1078
  • Karma: 11
  • Solihull, Near Birmingham England.
Re: Magneto issues?
« Reply #24 on: 08.04. 2013 16:39 »
Thats a fair point, but it might just be the problem. Fitting a brightspark is easy, it will eliminate the dodgy condensor worry, and it will give you the reason to re-set your timing too. All for about 15 quid.  *smile*

No connection.
Regards

Andy

1958 Super Rocket
Plus
Harley Super Glide Custom
Yam XJR 1300

Offline BSA500

  • Resident Legend
  • *****
  • Join Date: Dec 2007
  • Posts: 911
  • Karma: 4
  • Tonbridge,Kent,UK
Re: Magneto issues?
« Reply #25 on: 09.04. 2013 12:24 »
That's  probably what I would end up with-no connection  *smile*. If it was the condenser, from previous experience, would it not be difficult to start, run rougher esp when hot. My only symptoms are the stutters under acceleration. She ticks over like a clock(better after fitting the spare carb),starts first/second kick even when hot and barring the stutters accelerates really well. There is no spit back but at the mo some pinking(timing?). I really must speak sweetly to she who holds the money about rebuilding the correct carb(1 inch not the current 15/16) and new needle/jet etc and going from there unless someone has any more possible reasons?

1960 A7 (57 motor to SS spec)

Online Triton Thrasher

  • Scotland
  • Wise & Enlightened
  • *
  • Join Date: Feb 2009
  • Posts: 1927
  • Karma: 23
Re: Magneto issues?
« Reply #26 on: 09.04. 2013 20:57 »
Missing under acceleration.

Can be a problem in the HT side of the ignition.  Close the plug gaps to about 8 thou. If that helps, well, at least you've eliminated the carburettor as the cause.

Offline BSA500

  • Resident Legend
  • *****
  • Join Date: Dec 2007
  • Posts: 911
  • Karma: 4
  • Tonbridge,Kent,UK
Re: Magneto issues?
« Reply #27 on: 10.04. 2013 08:40 »
Well it seems Triton Trasher wins todays prize. Closed the gaps and no stutter-hoorah. Of course this means there is an issue with the mag-boooo.

1960 A7 (57 motor to SS spec)

Offline KenF

  • Moving Up
  • **
  • Join Date: Feb 2012
  • Posts: 36
  • Karma: 6
Re: Magneto issues?
« Reply #28 on: 10.04. 2013 17:14 »
Well done, TT.

BSA500, if you're after a mag troubleshooting guide, please pay a visit here http://brightsparkmagnetos.com/DIY.

You may have a condenser problem, but I guess it's more likely to be a breakdown of the insulation around the HT winding or of the slip-ring or pick-up. Sometimes you can detect a pick-up problem by putting your hand on it while the engine's running (but don't try that if you've got a pacemaker). Breakdowns of the winding insulation or slip ring are more difficult to detect without stripping the thing down completely and using a magneto coil tester.

Best of luck.

Ken
http://brightsparkmagnetos.com

Online Triton Thrasher

  • Scotland
  • Wise & Enlightened
  • *
  • Join Date: Feb 2009
  • Posts: 1927
  • Karma: 23
Re: Magneto issues?
« Reply #29 on: 10.04. 2013 17:54 »
Well it seems Triton Trasher wins todays prize. Closed the gaps and no stutter-hoorah. Of course this means there is an issue with the mag-boooo.

I suppose you've eliminated the cheap possibilities like bad plugs, cracked pickups, HT lead or plug insulators tracking, buildup of oily stuff on pickups?