Dynamo a10 F and D.

[michael snellin]

Hi, everyone, just wanted to know the two wires/leads from the yoke on the above item does it matter what way round they go ???they seem to be identical with inpregnated oil.
                                                   thanks.

[morris]

It does. If they are the wrong way round the dynamo won't deliver power

[metalflake11]

Where the wires go into the dynamo, there should be f and d stamped next to them. That will tell you which is which.
.                      mf

[Beezageezauk]

Hi Michael,

I don't mind admitting that electrics are my weak point but after studying the Lucas Workshop instructions one of the diagrams shows the 2 brushes.  One of these brushes is attached to earth.  The other one appears to go to the "D" terminal.

Anyway, that's how I connected my dynamo up last week and it's working fine.

I'm sure somebody on the forum will comment if I'm wrong.

Beezageezauk.

[Gerry]

Hi Michael, One brush and one end of the field coil go to earth, the other brush goes to the D terminal (Dynamo) and the other end of the field coil goes to the F terminal, these two output wires then match up with the D and F connections on the reg/cutout. Yellow is D and green is F. Hope this helps. Cheers. Gerry