Author Topic: 8 in single sided brake alloy backplate  (Read 306 times)

Offline Andy51

  • Active
  • *
  • Join Date: Jul 2016
  • Posts: 2
  • Karma: 0
8 in single sided brake alloy backplate
« on: 10.08. 2016 21:59 »
Hi, I am fitting a BSA 8 in single sided brake to an AJS bike.  Thanks for the rim offset info; now another question.  The alloy brake back plate has a 7/16 20 tpi stud for the torque arm between fork leg and backplate.  This stud is fitted through the backplate and is secured by a nut on the inside face, the end of the stud has been peened over to stop the nut loosening; the stud is obviously not intended to be removed in normal service.  How do I replace it?  Is the stud threaded into the alloy with a locknut for security, or is it a push fit, held in by the nut?  Do I file/drill away the peening, remove the nut, lock 2 nuts on the stud and unscrew, or press it out?  Does the stud come loose easily without damaging the softer alloy, or would I be better leaving it in place as the risk of damage is too high?  Thanks, Andy
Good Advice
0
No reactions

Online morris

  • Wise & Enlightened
  • *
  • Join Date: Aug 2012
  • Posts: 1648
  • Karma: 26
  • Antwerp, Belgium
Re: 8 in single sided brake alloy backplate
« Reply #1 on: 11.08. 2016 08:11 »
Hi Andy, the stud is not only secured by the nut on the inside, but also screwed in the alloy.
If I remember well, the part of the stud that screws in the alloy is ww thread. It may also be secured by some Loctite or similar, so can be a real pain to remove
If you decide to remove it make sure that, after removing the inner nut, the thread is in good shape or you'll ruin the thread in the alloy plate.
Good Advice
0
No reactions
'58 BSA A 10 SA
'52 BSA A 10 Plunger
'55 MORRIS ISIS
The world looks better from a motorbike
Belgium

Online Bsareg

  • Valued Contributor
  • ****
  • Join Date: Mar 2016
  • Posts: 289
  • Karma: 2
Re: 8 in single sided brake alloy backplate
« Reply #2 on: 11.08. 2016 10:06 »
Hi, if you heat the alloy to to spit & sizzle (tech term) zone, most loctite type products will "let go". Hope this helps. Bsareg
Good Advice
0
No reactions
C11,B40,B44 Victor,A10,RGS,M21,Rocket3,REBSA