Rear guard

[Russ]

I am test fitting my rear guard to my 51 A10. I have two sets of brackets, however, the original one is slightly bent and I need to establish if the other is a correct fit.
If possible, I need the measurements from the bracket mounting points to the guard. "See picture attached".
Thanks in advance,
Russ

[WozzA]

Centre to centre of the holes..
Blue..... 425 mm
Red.....  360 mm
Green... 380 mm
         

[Greybeard]

I'll go and measure mine in a minute..and the mudguard stays!

[Russ]

I rang WozzA tonight after posting this request and at 8.30pm on an average Melbourne night he ventured out to his shed and took the necessary measurements to reply to my post.
Greatly appreciated, thanks mate.
Russ

[Russ]

I should also thank Brian, the photo I used was pinched from one of his earilier posts.

[Greybeard]

Sorry Russ; I forgot. 

I get 420, 365 and 375 in the same sequence as Wozza

[morris]

420, 365 and 380 mm

[Russ]

Thanks Greybeard and Morris for your helpful input.
Russ