Oil filter modification

[oldbeezageezer]

Hi Col.
I tried sending pics of attachment but not accepted as too large.
I have a dremel 3000 and on the dremel paperwork I have part nos are SC402 and SC456. I'll send pics if I figure out how to up load them.
Alan

[oldbeezageezer]

Hi Col

Managed to load photos of my tool box and the dremel attachment. Ignore the two large holes at the top of the toolbox. These were the location of the oil pipes as per supplied template. Unfortunately one of them was right up against the rear mudguard. Should have checked before drilling!!

You can see the top and bottom bits of the partition still in place.
Alan

[Colsbeeza]

Thanks Alan OBG,
 That gives me a quick kick start. It is flooding here, so cannot go out at the moment. Will get one on-line.
Who'd-a-thought that after several years of the worst drought in Oz History that I'd be building Noah's Ark.
Col