Author Topic: A7 Scavenge pipe  (Read 1047 times)

Offline olev

  • Brisbane, Australia
  • Valued Contributor
  • ****
  • Join Date: Sep 2008
  • Posts: 493
  • Karma: 3
A7 Scavenge pipe
« on: 18.10. 2008 12:32 »
gday,
I need to replace the scavenge pipe in the timing side crankcase of my A7.
It is a very tight fit.
Does anyone have any tips for removing the old one other heating the case, then grabbing the tube with a set of multigrips and giving it a good twisting and reefing.
Is there any tricks replacing it. Obviously the seal to the case is critical or it will suck in air.
cheers, Tom

Online a10gf

  • Wise & Enlightened
  • *
  • Join Date: Sep 2006
  • Posts: 2769
  • Karma: 42
  • West Coast, Norway & Alpes Maritimes, France
    • A10 GF
Re: A7 Scavenge pipe
« Reply #1 on: 19.10. 2008 14:21 »
Hello, I think you have outlined the process already, just be careful to not break the tube so that any parts remain stuck in the case alu, use patience and go slowly until it starts moving. I'd think a dash of green loctite on the new pipe at insertion would do good. Good luck
e.

A10 GF '53 My A10 website
"Success only gets you a ticket to a much more difficult task"

Offline dpaddock

  • NC, USA
  • Valued Contributor
  • ****
  • Join Date: Jul 2006
  • Posts: 429
  • Karma: 5
Re: A7 Scavenge pipe
« Reply #2 on: 22.10. 2008 02:46 »
And neither is loctite.
David
'57 Spitfire